According to the conversion method, the load cell is divided into 8 types: photoelectric, hydraulic, electromagnetic, capacitive, magnetic pole change form, vibration type, gyro ceremony, resistance strain type, etc. The resistance strain type is the most widely used. Photoelectric:Including two kin
The load cell is actually a device that converts the quality signal into a measurable electrical signal output. The actual working environment of the sensor should be considered first when using the sensor. This is very important for the correct selection of the load cell. It is related to the norma
1. Monitoring(1) Monitoring of empty scales with load cells. Under actual weighing conditions, the load-bearing device weighs the body (or load-bearing weighingThe frame) is in place, and the mechanical parts are in place. Measure the output value of each sensor of the scale under the excitation vol
[Abstract] This article introduces a principle and method of early and accurate diagnosis of the "sub-health" condition of load cells.[Keywords] early; diagnosis; "sub-health"; load cell; methodI. Introduction With the continuous deepening of enterprise technological transformation, electronic weigh
The accuracy grade of the loadcell includes the loadcell's nonlinear, creep, creep recovery, hysteresis, repeatability, sensitivity and other technical indicators. When choosing a load cell, do not simply pursue a high-level loadcell, but consider both the accuracy requirements of the electronic sca
S-type load cell installation method① Directly pull out both ends of the upper and lower threads vertically or horizontally to measure the tensile force. ②One end is fixed on the equipment through the threaded hole, and the other end is used for pressing. (As used in the experimental press, directly